Apparently a lot of you have vintage Aermacchi motorcycles!

I'm currently making these tools in small lots as demand dictates, so availability will vary.  If the banner below shows the tools are availiable, feel free to place an order. 

If not, simply contact us for an update on when the next lot will be produced.

ALSO - we're adding to the line with tools for other Aermacchi models, as well as other manufacturers bikes!  Stay tuned!

TOOLS IN STOCK!

Check back often - status changes frequently

ALL NON-US ORDERS - CONTACT US FIRST, PLEASE!

US orders note: If you purchase the clutch/case/crank press and splitter tool,
the other tools can be added for no extra shipping charge!

 

Aermacchi
Clutch/Case/Crank Press / Splitter tool set

$125.00 + $11.35 Priority Air Shipping

(Price for US orders ONLY)

This is a disassembly multi-tool for the Aermacchi Sprint models.  It does the work of FOUR different tools! 

1.) Clutch Press - This will apply pressure to the           clutch to allow safe removal of the retaining

          ring and clutch spring.

2). Case Splitter - Applied to the right crank, this tool

          will press the two case halves apart.

3.) Crank Press - Apply to the left crank to remove

          the crank from the cases.

4.) After removing retaining pins from the shift forks

         you can apply this to the mainshaft to press

         out the mainshaft for transmission removal.

AND

This tool will re-install the crank with the use of the crankshaft installer tools listed below!

 
     

Aermacchi Sprint Armature Tool Only

$45.95 + $5.99 s&h

(Price for U.S. orders only)

 

Aermacchi - Harley Sprint Armature puller for generator models. 

NOT FOR ELECTRIC START MODELS

Tested on '68 Sprint 250 SS.

Specs: This puller has a left-hand threaded body that screws into the armature tach-drive threads.  Armature opening is approx.  .652 diameter at
thread peaks.

         

Puller body is leaded brass, handle is cold-rolled steel, TIG welded to threaded rod, and end thimble is O1 tool steel.

 
     

Aermacchi Sprint Crankshaft Installer Tool Set

$49.99 + $5.99 s&h

(Price for U.S. orders only)

 

Crankshaft Installer Tool set - This set works with the Clutch/Case/Crank Press / Splitter tool set listed above. 

NOT FOR ELECTRIC START MODELS

There are adaptors for both ends of the crank; you simply set the Press/Splitter tool body over either end of the crank, screw in the threadded rod through the press/splitter tool and into the adaptor, then spin the drawing nut tool over that.  It'll pull either end of the crank in cleanly and easily, for installing the crank, closing the cases or measuring end-play.

An invaluable re-assembly tool.